![]() The Bus Pirate firmware can also be updated over the USB connection using a bootloader, so the ICSP header is normally only used to program it the first time at the factory. These pins can be used to write new firmware to the microcontroller with a programmer like the PICKIT2 or ICD2. In circuit serial programming (ICSP) header. This 1x5 block of 0.1" pin header is the programming connection for the PIC 24FJ64GA002 microcontroller. Notes: * TX moved from CS to MOSI in firmware v0għ. Ground, connect to ground of test circuit Voltage input for on-board pull-up resistors (0-5volts). Master data in, slave out (SPI, JTAG) RX (UART)Īuxiliary IO, frequency probe, pulse-width modulator Master data out, slave in (SPI, JTAG), Serial data (1-Wire, I2C, KB), TX* (UART) Image shows Colors from BusPirate ProbeKit available at Seeed Studio on latest Version
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |